Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Background :
There are two data centers in my environment : Site A and Site B.
Site A is more like main site while Site B is like DR site since most of the servers are in Site A.
But the traffic from branches will equally spread into both sites b...
Hi,I am using Prime LMS 4.2 automated action to run a script sending out messages to SMS.But the content of message is IP address not hostname.Is there any option that I can change the IP address to hostname?I have check the "hosts" file, there is a ...
Hi,Is there any way to do a nac agent auto provision?I know it can be achieve by cwa portal(web redirect) and user have to install nac agent manually. But we would like to see nac agent be installed right afeter user successfully login using 802.1x.
Hi,I am using 3850 and 5760 with converged access mode.There is also ISE to provide dACL for wireless user.In 3850, I can issue "show access-list" to see the dACL from ISE.But I can't be sure which ACL apply to which user when there are more than one...
Hi,Product: Cisco Prime NAM Appliance 2304Version: 5.1(3)Problem: We only can see MAC address on Hosts table in NAM, not IP address.Does anyone know what happen and how to fix it?Thanks!!!
Hi,I found the option in LMS finally, please check the attached file.After I enable that option, I check the register value you mentioned.That value is changed to 1 as you said. And the syslog report is normally now.Thanks!!!
Hi,Thanks for your reply. I have followed your instructions.But after I done that, the syslog stops unexpectedly.The crmlog service is running but the syslog report is empty.Did I do anything wrong?
Hi,I have the same issue. Does anyone know how to use "Include custom text in body of email" ?There is nothing in administration guide about how to use this function.Thanks.
Hi,I got the same problem on C460M2.If attach one LOM to Switch, both CIMC and ESXi are fine.If attach two LOM to Switch with port-channel, CIMC failed but ESXi is fine.I use Active-Active CIMC by the way.
