07-17-2013 12:02 PM
Hello all,
I am trying to connect to the console of this SG300-10 using a Cisco console cable, but am not getting anywhere with an actual connection. I am using Putty with the settings of 9600-8-n-1-None-None. I have also tried with baud rate of 19200, but no difference. I cannot seem to get to the console of this switch. Is it possible that Cisco disabled the console port of this switch? I would like to configure the VLANs on the switch and find the GUI extremely confusing to use.
Thougthts? Suggestions?
Thank you!
Solved! Go to Solution.