Hi
we are implementing a new MPLS WAN design. The MPLS WAN design will use BGP.
The first office to go will be Shelton.
on our 1006 router that will be the Main Campus router(aggregation router for the remote site offices) we're going to configure BGP for the network connected to the PE router.
On the 1006 router we will have 3 routing protocols - EIGRP, OSPF and BGP. We are in the middle of transitioning from OSPF to EIGRP.
At this point we have EIGRP redistributed into OSPF and OSPF redistributed into EIGRP on the 1006 router and on the MK-VPN-1001 and AP-VPN-1001
routers we have a similiar redistribution although there is a route map there for loop preventing purposes.
Because we are planning on moving to EIGRP for the Main Campus and the remotes offices, should we only redistribute BGP into EIGRP because EIGRP will then redistribute into OSPF?
Also, should we be concerned about loops?
Thank you.
