Hi,
Can any one help, how to calculate bandwidth utlization from " sh int" details..?
Can the percentage will get calculated from rx tx values..?
I am using 4 mbps lease line.
FastEthernet0/0/0 is up, line protocol is up
Hardware is FastEthernet, address is 001a.6c70.4b14 (bia 001a.6c70.4b14)
Description: Internet Connection
Internet address is 1.1.1.1/30
MTU 1500 bytes, BW 4000 Kbit, DLY 100 usec,
reliability 255/255, txload 31/255, rxload 120/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 828000 bits/sec, 111 packets/sec
5 minute output rate 498000 bits/sec, 92 packets/sec
788931865 packets input, 4036778275 bytes
Received 398 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
571607354 packets output, 3639639717 bytes, 0 underruns
Thanks in Advance,
Regards,
Ninad Thakare
