Hello, Cisco community!
Currenlty UCS manager shows two Fabric Interconnects, and two Fabric Extenders, but for some reason my server isn't showing up
Here is the birds eye view:
I have my C240 connected with two 10GbE twinax cables, each going to one fabric extender. (2 FEX total)
I have two 10GbE twinax cables connected from the fiber module of each FEX to each Fabric interconnects. (2 FI total)
The fabric interconnect ports L1 and L2 ports are connected to their corresponding ports. So their connected to each other.
I run 'show cluster extended-state' on the primary FI and this is what i get:
FI-A# show cluster extended-state
Cluster Id: 0xebaad0e28ded11e3-0x86d4002a6a153d84
Start time: Wed Feb 5 16:07:44 2014
Last election time: Wed Feb 5 16:23:26 2014
A: UP, PRIMARY
B: UP, SUBORDINATE
A: memb state UP, lead state PRIMARY, mgmt services state: UP
B: memb state UP, lead state SUBORDINATE, mgmt services state: UP
heartbeat state PRIMARY_OK
INTERNAL NETWORK INTERFACES:
eth1, UP
eth2, UP
HA NOT READY
No device connected to this Fabric Interconnect
After configuring the server-side ports on each FI, the server still doesn't show up
Any idea are highly appreciated!!
-Alex
