Hi Everyone,
I need to do a password recovery for one of my clients that has 3 2960x switches, all stacked. I was wondering if there is anything I need to know about doing one switch at a time and powering them off. If, I power one switch down to do the recovery, will that cause issues for the others in the stack? Do I need to disconnect the stack master?
This is the article I believe that I need to reseting the passwords: http://www.cisco.com/c/en/us/support/docs/switches/catalyst-2950-series-switches/12040-pswdrec-2900xl.html
Any gotcha's I should look out for?
Thanks!
