03-23-2022 02:56 AM
Hi! We have several Cisco AP 9120 AXI which is not joining WLC and the obvious reason is no IP. When connecting to the AP via console you will see what is shown below.
Other Aps on the same switch is working okay and all are new. I saw the is shipped with ver 8.10.x
We will run them on 17.6.2 on WLC 9800-CL
Have found a bug case with now solution https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvm96943
We have tried the old trick with IP-helper and IP forward protocol udp 5246 with no better result.
When we set the IP manually with wlc IP it works and register /upgrades software. If you then delete the static IP you are back in green mode again..
Anyone seen this and hopefully found a solution?
[*03/22/2022 14:32:30.3730] <=== Deactivate Deep Green Mode
[*03/22/2022 14:32:30.3730] bcmswlpbk0 (Ext switch port:
[*03/22/2022 14:32:45.7260] wired0 (Ext switch port: 7) (Logical Port: 15) (phyId: 1f) Link DOWN.
[*03/22/2022 14:32:45.7260] ===> Activate Deep Green Mode
[*03/22/2022 14:32:45.7260] bcmswlpbk0 (Ext switch port:
[*03/22/2022 14:32:47.8330] wired0 (Ext switch port: 7) (Logical Port: 15) (phyId: 1f) Link Up at 1000 mbps full duplex
[*03/22/2022 14:32:47.8330] <=== Deactivate Deep Green Mode
[*03/22/2022 14:32:47.8330] bcmswlpbk0 (Ext switch port:
[*03/22/2022 14:33:02.0820] wired0 (Ext switch port: 7) (Logical Port: 15) (phyId: 1f) Link DOWN.
[*03/22/2022 14:33:02.0820] ===> Activate Deep Green Mode
[*03/22/2022 14:33:02.0820] bcmswlpbk0 (Ext switch port:
[*03/22/2022 14:33:04.1890] wired0 (Ext switch port: 7) (Logical Port: 15) (phyId: 1f) Link Up at 1000 mbps full duplex
[*03/22/2022 14:33:04.1890] <=== Deactivate Deep Green Mode
[*03/22/2022 14:33:04.1890] bcmswlpbk0 (Ext switch port:
*03/23/2022 08:44:01.2970] ERROR: return from vap_amsdu_rx_max was -45
[*03/23/2022 08:44:01.6800] DOT11_DRV[1]: set_channel Channel set to 36/20
[*03/23/2022 08:44:02.3790] wl: Unsupported
[*03/23/2022 08:44:02.3790] ERROR: return from vap_amsdu_rx_max was -45
[*03/23/2022 08:44:02.7870] DOT11_DRV[1]: set_channel Channel set to 36/20
[*03/23/2022 08:44:02.9900] DOT11_DRV[1]: set_channel Channel set to 36/20
[*03/23/2022 08:44:03.6900] wl: Unsupported
[*03/23/2022 08:44:03.6910] ERROR: return from vap_amsdu_rx_max was -45
[*03/23/2022 08:44:04.0220] wl: Unsupported
[*03/23/2022 08:44:04.0220] ERROR: return from vap_amsdu_rx_max was -45
[*03/23/2022 08:44:04.6170] DOT11_DRV[1]: set_channel Channel set to 36/20
[*03/23/2022 08:44:07.7050] IOT Bootloader Flash Tool 1.4
[*03/23/2022 08:44:07.7050] Firmware upgrade initiated by ble_init
[*03/23/2022 08:44:07.7050] bundled_ver_split ['2', '7', '20']
[ OK ] Started BLE init service.
[ OK ] Reached target Multi-User System.
[*03/23/2022 08:44:26.1310] wired0 (Ext switch port: 7) (Logical Port: 15) (phyId: 1f) Link DOWN.
[*03/23/2022 08:44:26.1310] ===> Activate Deep Green Mode
[*03/23/2022 08:44:26.1310] bcmswlpbk0 (Ext switch port:
[*03/23/2022 08:44:28.2370] <=== Deactivate Deep Green Mode
[*03/23/2022 08:44:28.2370] bcmswlpbk0 (Ext switch port:
[*03/23/2022 08:44:28.2370] wired0 (Ext switch port: 7) (Logical Port: 15) (phyId: 1f) Link Up at 1000 mbps full duplex
[*03/23/2022 08:44:42.4870] wired0 (Ext switch port: 7) (Logical Port: 15) (phyId: 1f) Link DOWN.
[*03/23/2022 08:44:42.4870] ===> Activate Deep Green Mode
[*03/23/2022 08:44:42.4870] bcmswlpbk0 (Ext switch port:
[*03/23/2022 08:44:44.5930] <=== Deactivate Deep Green Mode
[*03/23/2022 08:44:44.5930] bcmswlpbk0 (Ext switch port:
[*03/23/2022 08:44:44.5930] wired0 (Ext switch port: 7) (Logical Port: 15) (phyId: 1f) Link Up at 1000 mbps full duplex