Hello all,
we recently received 2x Cisco C9124AXE and we need to use them for a point-to-point wireless bridge between two buildings as shown in the image. How can we configure them? They are brand new, I didn't convert them to any mode or EWC... I am just asking for the correct steps. I would be glad for any suggestions. C9124AXE firmware version: 17.6.2.43
We have only these two APs and don't have a C9800 controller so we plan to convert one C9124 to EWC. This is our idea:
1. Convert C9124_A to EWC
2. Join C9124_B to this C9124_A EWC
3. Configure mesh according to documentation
4. Switch C9124_B to Flex+Bridge mode
5. Switch C9124_A to Flex+Bridge mode. But this C9124_A is EWC at the same time. Will this work? Or do I need a third device - C9800 WLC or AP that will server as EWC?
Or do you have any other suggestions on how to make it work?
Thank you!
