We are deploying Dante devices on the network using C9600 core switch and C9300 as the edge switches.
All Dante devices are in the same VLAN subnet.
Using a Dante Controller to discover the devices using multicast, we can only see devices on same switch where the Dante Controller PC is connected.
https://www.youtube.com/watch?v=QKB5PBLHLlI
But we cannot see the Dante devices on the other switch. We can reach the all the devices IP addresses using ping.
But if we bypass the core switch C9600 (direct connect C9300 to C9300) we can see the all the devices.
I am not sure what the C9600 is doing with the multicast traffic.
