03-10-2013 11:19 AM
I'm trying to telnet into the my RV180 router. How do I go about it.
I created 3 VLANS
1 at 192.168.1.1
20 at 192.168.20.1
30 at 192.168.30.1
Here is the Multiple VLAN Subnet Table:
1 | 192.168.1.1 | 255.255.255.0 | DHCP Server | Enabled | ||
10 | 192.168.10.1 | 255.255.255.0 | DHCP Server | Enabled | ||
20 | 192.168.20.1 | 255.255.255.0 | DHCP Server | Enabled |
I can ping the router at all 3 IP addresses.
How do I enable the telnet service on the router?
Solved! Go to Solution.
03-10-2013 12:46 PM
Hi Willy, this router does not support a telnet/cli.
-Tom
Please mark answered for helpful posts
03-10-2013 12:46 PM
Hi Willy, this router does not support a telnet/cli.
-Tom
Please mark answered for helpful posts
03-19-2015 07:52 AM
Betreffend telnet und RV180:
Unter dem Menü-Punkt:
"Administration" - "Management Interface" - "Web Access"
kann man "Remote Management" auf "enable" setzen
und weiter unten auch den Punkt "Port" auswählen (Standardmässig HTTPS 443)
Wofür steht diese "Remote Management" Einstellung, wenn nur HTTPS funktioniert?
Das Problem ist, dass der RV180 zwar "no-ip.com" ergänzt hat, aber andere Seiten wie die hier beschriebene und weit umfangreichere nicht:
http://www.blindhog.net/cisco-routers-and-dynamic-dns/
Die Anleitung würde eine Konfiguration anderer dyndns Seiten zeigen, die per SSH oder Telnet konfiguriert werden könnten....
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide