Question about subnet's on RV016

[prodansergeyod1]

Hallo community!

I have a question.

I have default LAN 192.168.0.x/255.255.255.0 on my RV016 port1 (Vlan1).

Than I connect lvl1 switch to port13 (Vlan1) via subnet (192.168.10.x/255.255.255.0)

Result is pretty good. I have Internet connection on both subnets. I can ping and tracert all IP's from subnet 0.x to 10.x. But from 10.x to 0.x i can ping only a few IP's. What's wrong? RIP on my RV016 is disable. And i don't configure any static routes because i don't have another router on subnet 10.x. only lvl1 switch.

[Shawn Guertin]

Is it the same vlan on both subnets?

Could you post the run? that would be easier to follow.

[prodansergeyod1]

Yes both port-vlan is the same (as i said on first post)

yes i can ping some IP's from subnet B(10.x) to subnet A(0.x) but not them all.

From subnet A to subnet B i can ping all the IP's.

Subnet A:

192.168.0.50

255.255.255.0

Subnet B:

192.168.10.50

255.255.255.0

Subnet A is connect to RV016 via lvl2 switch 192.168.0.49 (without config vlan on this switch)

Subnet B is connect to RV016 via lvl1 switch

[Shawn Guertin]

You should show me the full configuration of your router, because it does not make sense the way you are trying to explain it. Maybe also a diagram?

[prodansergeyod1]

U ask me about backup.conf or what?