07-02-2015 11:58 AM
Hallo community!
I have a question.
I have default LAN 192.168.0.x/255.255.255.0 on my RV016 port1 (Vlan1).
Than I connect lvl1 switch to port13 (Vlan1) via subnet (192.168.10.x/255.255.255.0)
Result is pretty good. I have Internet connection on both subnets. I can ping and tracert all IP's from subnet 0.x to 10.x. But from 10.x to 0.x i can ping only a few IP's. What's wrong? RIP on my RV016 is disable. And i don't configure any static routes because i don't have another router on subnet 10.x. only lvl1 switch.
07-02-2015 12:30 PM
Is it the same vlan on both subnets?
Could you post the run? that would be easier to follow.
07-02-2015 12:47 PM
Yes both port-vlan is the same (as i said on first post)
yes i can ping some IP's from subnet B(10.x) to subnet A(0.x) but not them all.
From subnet A to subnet B i can ping all the IP's.
Subnet A:
192.168.0.50
255.255.255.0
Subnet B:
192.168.10.50
255.255.255.0
Subnet A is connect to RV016 via lvl2 switch 192.168.0.49 (without config vlan on this switch)
Subnet B is connect to RV016 via lvl1 switch
07-03-2015 06:21 AM
You should show me the full configuration of your router, because it does not make sense the way you are trying to explain it. Maybe also a diagram?
07-03-2015 07:46 AM
U ask me about backup.conf or what?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide