RV 340 Site to Site VPN with 2 vlan

[ChristianLeonardGuevarra7732]

Hello

I have setup site to site VPN connection between two RV340 routers with just single Vlan on both sides and it works great.

Recently we created 2 Vlan in Site "B" and the connection still working but I found out that the Vlan2 in Site "B" can't ping the Vlan in Site "A".

How can I setup the Vlan 1 & 2 in Site "B" can ping the Vlan in Site "A"??

Please someone give me some rough idea on how should I setup this one.

Thanks

[bfreeman4104]

I have this same issue.  Has there been resolution?

[nagrajk1969]

Hi

Supposing that your deployment is as below:

(vlan1-subnet)----[RV340-GW1](wan1)-----{internet-isp-router}-------(wan1)[RV340-GW2]---(van1/vlan2-subnets)

On GW1:

vlan1-subnet is 192.168.1.0/24

On GW2:

vlan1-subnet is 192.168.2.0/24

Note: you need to change the default vlan1 subnet on GW2 to 192.168.2.x (or any other suubnet other than 192.168.1.x...if you want to have s2s-tunnel to RV340-GW1)

vlan2-subnet is 192.168.4.0/24

----------------------------------

So before configuring the S2S tunnel on both GWs, do the following:

Step-1:

On GW1:

In system-management/ip-groups page of GUI, configure a remote-ip-group as below:

name: remoteGW2grp1

ip-subnet1: 192.168.2.0/24

ip-subnet2: 192.168.4.0/24

- apply and save it

Step-2: On GW2

In system-management/ip-groups page of GUI, configure a local-ip-group as below:

name: LocalGW2grp1

ip-subnet1: 192.168.2.0/24

ip-subnet2: 192.168.4.0/24

- apply and save it

Step-3: On GW1 configure the S2S tunnel, with the below settings included

Local-IP-Type: Subnet 

- enter the vlan1 subnet 192.168.1.0/255.255.255.0

Remote-IP-Type: IP-Group

- select the remoteGW2grp1

All other settings are as configured before for single subnet tunnel

Step-4:  On GW2 configure the S2S tunnel, with the below settings included

Local-IP-Type: IPGroup 

- select the LocalGW2grp1

Remote-IP-Type: Subnet

- enter the GW1-vlan1 subnet 192.168.1.0/255.255.255.0

All other settings are as configured before for single subnet tunnel

NOTES:

- although you may have already configured as such...but no harm done in repeating it again

a) Ensure to configure the Default-Gw ipaddr (of the respective subnets) pointing to the respective ipaddress configured on RV340s

Hope this is useful..