SRP541W firmware won't upgrade

[johnmanko1]

I have an SRP541W, and when I try to upgrade the firmware from 1.2.4 to 1.2.6 I get an error:

Upgrade has failed.

SRP541W is restarting...You will be returned to the Login page in few minutes.

After the reboot I check the logs, but there are no entries.  Any help would be appreciated.  I really hate this router.  Nothing but problems from day-one.  I don't think I'll ever buy another Cisco product again.  Arrrrr!

[Daniele Giordano]

You can try to download again the firmware, use a different browser or use a provisioning update url command like this:

http://SRP_IP_ADDRESS/admin/upgrade?http://WEB_SERVER/SRP520_1.2.6_003_051313_1047.bin

or

http://SRP_IP_ADDRESS/admin/upgrade?tftp://TFTP_SERVER/SRP520_1.2.6_003_051313_1047.bin

Regards.

[Andrew Hickman]

Hi John,

Sounds like your new version of 1.2.6 may have been corrupted (the SRP verifies the new image before attempting to boot from it - if that verification fails, it rolls back to the previous version).

Please download the image again and try again. You can use an MD5 checksum application to verify the image before installing if you wish.  The checksum is published on the same page as the firmware download.

Regards,

Andy