2811 router can support E1 card

[iqbalkhan]

Hi

I have a 2811 router , this router support E1 card ??.

thanks

biplob

[network.king]

Hi

If your query was abt the channelised E1 card , then it supports NM-2CE1T1-PRI card.

In case if you require further info , go to the tools option in cisco site and look out for dynamic configuration tool --guest login is fine and you can search for the same.

regards

vanesh k

[smothuku]

Hi Biplob ,

The below link gives info about supported cards on 2811 router.

http://www.cisco.com/en/US/products/ps5854/prod_module_install_config_guide09186a00802c9351.html#wp1061244

Hope this helps you.

Thanks,

Satish

[clausonna]

I have a few 2821's running the VWIC-1MFT-G703 WIC, which supports E1 circuits. One site is in Ireland and the other is in Germany. I think your best bet is to ask your ISP exactly how they are going to 'deliver' the circuit (framed/unframed, PPP/Frame Relay) and then verify with them which WIC you should buy. But in general, I think a 2811 should be fine.

Relevant info from one of my configs:

controller E1 0/0/0

channel-group 0 unframed

!

interface Serial0/0/0:0

description Outside Interface

ip address

encapsulation ppp

!------

router#show controllers e1

E1 0/0/0 is up.

Applique type is Channelized E1 - balanced

No alarms detected.

alarm-trigger is not set

Version info Firmware: 20051006, FPGA: 20, spm_count = 0

Framing is UNFRAMED, Line Code is HDB3, Clock Source is Line.

CRC Threshold is 320. Reported from firmware is 320.

Data in current interval (619 seconds elapsed):

0 Line Code Violations, 0 Path Code Violations

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

Total Data (last 24 hours)

0 Line Code Violations, 0 Path Code Violations,

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,

0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs