2811 router sh tech nm port not working

[ramnet communications pvt ltd]

Dear All,

2811 router sh tech nm port not working,

plz suggest me.plz find the attachment.

[drolemc]

The 2811 do not support NM-1E1R or NM-2E. Ensure your Network module will support or not. Romove the Nm module And switch off the router then insert the module. Once you installed the restart the module and configure newly then try.

[paolo bevilacqua]

NM "what ?".

You've only sent show config.

Please describe the problem properly.

[Leo Laohoo]

I'll agree with the 2 post before me. What network modules did install? Aside from the NM-1E, I think you also put a NM-4T too.

The link below will tell you what modules you can install into your appliance. Good luck.

http://www.cisco.com/en/US/products/ps5854/products_data_sheets_list.html