cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1266
Views
0
Helpful
3
Replies

819 - Cellular interface-Profile - going down after some time

sarathcisco2013
Level 1
Level 1

819 - Cellular interface interface - going down after some time.

do any body have solution for that.

Profile gone permanently down after an hour .

sh run

!
chat-script hspa-R7 "" "AT!SCACT=1,1" TIMEOUT 60 "OK"
chat-script LTE "" "AT!CALL" TIMEOUT 20 "OK"
!
cts logging verbose 
!
controller Cellular 0

!
interface Cellular0
ip address negotiated
ip nat outside
ip virtual-reassembly in
encapsulation slip
load-interval 30
dialer in-band
dialer idle-timeout 0
dialer string hspa-R7
dialer-group 1
no peer default ip address
async mode interactive
routing dynamic
!
interface FastEthernet0
switchport access vlan 99
no ip address
duplex half
speed 100
spanning-tree portfast
!
interface FastEthernet1
switchport access vlan 99
no ip address
spanning-tree portfast
!
interface FastEthernet2
switchport access vlan 99
no ip address
spanning-tree portfast
!
interface FastEthernet3
switchport access vlan 99
no ip address
spanning-tree portfast
!
interface GigabitEthernet0
ip address 10.1.98.254 255.255.255.0
ip nat inside
ip virtual-reassembly in
duplex half
speed auto
!
interface Serial0
no ip address
shutdown
clock rate 2000000
!
interface Wlan-GigabitEthernet0
no ip address
!
interface wlan-ap0
no ip address
!
interface Vlan1
no ip address
!
interface Vlan99
ip address 10.1.99.254 255.255.255.0
ip nat inside
ip virtual-reassembly in
!
ip forward-protocol nd
no ip http server
no ip http secure-server
!
!
ip nat inside source list 1 interface Cellular0 overload
ip nat inside source route-map internet interface Cellular0 overload
ip route 0.0.0.0 0.0.0.0 Cellular0
!
dialer-list 1 protocol ip permit
!
route-map internet permit 10
match ip address 101
!
access-list 1 permit any
access-list 101 permit ip 10.1.98.0 0.0.0.255 any
!
control-plane
!
!
mgcp behavior rsip-range tgcp-only
mgcp behavior comedia-role none
mgcp behavior comedia-check-media-src disable
mgcp behavior comedia-sdp-force disable
!
mgcp profile default
!
!
!
!
!
!
!
line con 0
no modem enable
line aux 0
line 2
no activation-character
no exec
transport preferred none
transport input all
stopbits 1
line 3
exec-timeout 0 0
password cisco
script dialer hspa-R7
login
modem InOut
no exec
transport input all
line vty 0 5
password Cisc0123
login
transport input telnet
!
scheduler allocate 20000 1000
!
!
!
end

1 Accepted Solution

Accepted Solutions

Hello,

 

I have made some changes to your configuration (marked in bold):

 

sh run

!
chat-script hspa-R7 "" "AT!SCACT=1,1" TIMEOUT 60 "OK"
chat-script LTE "" "AT!CALL" TIMEOUT 20 "OK"
!
cts logging verbose
!
controller Cellular 0
!
interface Cellular0
ip address negotiated
ip nat outside
ip virtual-reassembly in
encapsulation slip
load-interval 30
dialer in-band
dialer idle-timeout 0
dialer string hspa-R7
dialer-group 1
no peer default ip address
async mode interactive
routing dynamic
!
interface FastEthernet0
switchport access vlan 99
no ip address
duplex half
speed 100
spanning-tree portfast
!
interface FastEthernet1
switchport access vlan 99
no ip address
spanning-tree portfast
!
interface FastEthernet2
switchport access vlan 99
no ip address
spanning-tree portfast
!
interface FastEthernet3
switchport access vlan 99
no ip address
spanning-tree portfast
!
interface GigabitEthernet0
ip address 10.1.98.254 255.255.255.0
ip nat inside
ip virtual-reassembly in
duplex half
speed auto
!
interface Serial0
no ip address
shutdown
clock rate 2000000
!
interface Wlan-GigabitEthernet0
no ip address
!
interface wlan-ap0
no ip address
!
interface Vlan1
no ip address
!
interface Vlan99
ip address 10.1.99.254 255.255.255.0
ip nat inside
ip virtual-reassembly in
!
ip forward-protocol nd
no ip http server
no ip http secure-server
!
ip nat inside source list 1 interface Cellular0 overload
--> no ip nat inside source route-map internet interface Cellular0 overload
ip route 0.0.0.0 0.0.0.0 Cellular0
!
dialer-list 1 protocol ip permit
!
--> no route-map internet permit 10
match ip address 101
!
--> no access-list 1 permit any
access-list 1 permit 10.1.98.0 0.0.0.255
access-list 1 permit 10.1.99.0 0.0.0.255
!
control-plane
!
mgcp behavior rsip-range tgcp-only
mgcp behavior comedia-role none
mgcp behavior comedia-check-media-src disable
mgcp behavior comedia-sdp-force disable
!
mgcp profile default
!
line con 0
no modem enable
line aux 0
line 2
no activation-character
no exec
transport preferred none
transport input all
stopbits 1
line 3
exec-timeout 0 0
password cisco
script dialer hspa-R7
login
modem InOut
no exec
transport input all
line vty 0 5
password Cisc0123
login
transport input telnet
!
scheduler allocate 20000 1000
!
end

View solution in original post

3 Replies 3

Hello,

 

I have made some changes to your configuration (marked in bold):

 

sh run

!
chat-script hspa-R7 "" "AT!SCACT=1,1" TIMEOUT 60 "OK"
chat-script LTE "" "AT!CALL" TIMEOUT 20 "OK"
!
cts logging verbose
!
controller Cellular 0
!
interface Cellular0
ip address negotiated
ip nat outside
ip virtual-reassembly in
encapsulation slip
load-interval 30
dialer in-band
dialer idle-timeout 0
dialer string hspa-R7
dialer-group 1
no peer default ip address
async mode interactive
routing dynamic
!
interface FastEthernet0
switchport access vlan 99
no ip address
duplex half
speed 100
spanning-tree portfast
!
interface FastEthernet1
switchport access vlan 99
no ip address
spanning-tree portfast
!
interface FastEthernet2
switchport access vlan 99
no ip address
spanning-tree portfast
!
interface FastEthernet3
switchport access vlan 99
no ip address
spanning-tree portfast
!
interface GigabitEthernet0
ip address 10.1.98.254 255.255.255.0
ip nat inside
ip virtual-reassembly in
duplex half
speed auto
!
interface Serial0
no ip address
shutdown
clock rate 2000000
!
interface Wlan-GigabitEthernet0
no ip address
!
interface wlan-ap0
no ip address
!
interface Vlan1
no ip address
!
interface Vlan99
ip address 10.1.99.254 255.255.255.0
ip nat inside
ip virtual-reassembly in
!
ip forward-protocol nd
no ip http server
no ip http secure-server
!
ip nat inside source list 1 interface Cellular0 overload
--> no ip nat inside source route-map internet interface Cellular0 overload
ip route 0.0.0.0 0.0.0.0 Cellular0
!
dialer-list 1 protocol ip permit
!
--> no route-map internet permit 10
match ip address 101
!
--> no access-list 1 permit any
access-list 1 permit 10.1.98.0 0.0.0.255
access-list 1 permit 10.1.99.0 0.0.0.255
!
control-plane
!
mgcp behavior rsip-range tgcp-only
mgcp behavior comedia-role none
mgcp behavior comedia-check-media-src disable
mgcp behavior comedia-sdp-force disable
!
mgcp profile default
!
line con 0
no modem enable
line aux 0
line 2
no activation-character
no exec
transport preferred none
transport input all
stopbits 1
line 3
exec-timeout 0 0
password cisco
script dialer hspa-R7
login
modem InOut
no exec
transport input all
line vty 0 5
password Cisc0123
login
transport input telnet
!
scheduler allocate 20000 1000
!
end

thanku,Georg Pauwen
i made the changes ,still cellular interface going down.
do i need to upgrade the modem firmware ,if so can u help me to find firmware.

Hello,

 

post the full config again including the changes you have applied...

Review Cisco Networking for a $25 gift card