- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-20-2012 08:12 AM - edited 03-04-2019 05:01 PM
Hi,
In a DMVPN implementation, I want to be able to create a report showing remote user bandwidth consumption of the headend interface by user's tunnel interface. In addition to configuring netflow on the headend, do I need to configure netflow on the remote routers? Or, would configuring netflow only to the headend be enough?
Also, is there a configuration needed on the router interface to tell Solarwinds how to interpret the flow - meaning, is there some setting I need to configure to make any Solarwinds report accurate? For instance, if the bandwidth utilization says 50%, I want that figure to actually be using 50% of the bandwidth on the interface. Hope that is clear.
Thanks, Pat.
Solved! Go to Solution.
- Labels:
-
Other Routing
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-23-2012 05:03 AM
Network monitoring applications let you define the circuit maxium speed as you desire for reporting purposes.
Thank you for the nice rating and good luck!

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-20-2012 04:21 PM
On the headend should be enough.
Once you start using the flow collector/analizer (each one can be different), it will be clear to you how they work.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-23-2012 04:57 AM
Thanks for the response. Could you also address the second question referring to bandwidth. Is there a command on the remote or headend side that should be configured to allow for accurate reporting. Does the bandwith setting on a particular interface influence how SolarWinds will report bandwidth consumption?
Thanks, Pat.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-23-2012 05:03 AM
Network monitoring applications let you define the circuit maxium speed as you desire for reporting purposes.
Thank you for the nice rating and good luck!
