cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
629
Views
0
Helpful
3
Replies

adding entry to existing access list

yeow28
Level 1
Level 1

i am trying to add new entry to an existing named extended access-list CORE but when i try to do so, i get this.

i cannot get the extended access-list name option 

 

0001(config)#access-list ?
<1-99> IP standard access list
<100-199> IP extended access list
<1100-1199> Extended 48-bit MAC address access list
<1300-1999> IP standard access list (expanded range)
<200-299> Protocol type-code access list
<2000-2699> IP extended access list (expanded range)
<700-799> 48-bit MAC address access list
dynamic-extended Extend the dynamic ACL absolute timer
rate-limit Simple rate-limit specific access list

 

Extended IP access list CORE
150 permit object-group ACCESS_PORTS object-group REMOTE_ACCESS object-group CORE

 

my IOS version is Version 15.0(1r)M16

2 Accepted Solutions

Accepted Solutions

luis_cordova
VIP Alumni
VIP Alumni

Hi @yeow28 

 

Try with:

 

0001(config)# ip access-list ?

 

Regards

View solution in original post

Hi @yeow28 

 

Remember to mark the correct answers as the solution, as that helps other users with similar questions

 

Regards

View solution in original post

3 Replies 3

luis_cordova
VIP Alumni
VIP Alumni

Hi @yeow28 

 

Try with:

 

0001(config)# ip access-list ?

 

Regards

thanks. forget about the all impt ip command.

it works now

Hi @yeow28 

 

Remember to mark the correct answers as the solution, as that helps other users with similar questions

 

Regards

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card