cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
437
Views
2
Helpful
17
Replies

After changing PPPOE max session , IPTV not connecting automatically A

saahiprahi
Level 1
Level 1

Team,

On this Te0/0/0.667 subinterface we have more than 200 users. so we set the PPPOE maximum session.

After setting up PPPOE maximum session to 1000 , IPTV not connecting automatically and getting option SKIP or RETRY. after select skip IPTV getting connected.

What will be the issue ? and what configuration we need to check in asr 1001X ?

interface TenGigabitEthernet0/0/0.667
encapsulation dot1Q 667
ip nat outside
ip pim sparse-mode
ip igmp access-group 10
pppoe enable group global
pppoe max-sessions 1000

 

17 Replies 17

Use threshold keyword 

Abd see if routet generate any log for high session numbers 

MHM

what is the command to set threshold

sessions max limit number-of-sessions [threshold threshold-value]

MHM

since we both suspect that this issue of session limit reach so 
what make session keep count ?

I think you missing keepalive under PPP 
keepalive 60 20

MHM

we set keepalive 12 under ppp is that ok or can i change it to keepalive 60 20

 

change it to 60 20 and monitor 

MHM

changed to 60 20 still issue is there. can i share you video for your reference

 

sessions max limit number-of-sessions this command is not accepting in ASR 1001-X

Hello,

have you tried to clear all PPPOE sessions ? I think the command is:

clear pppoe all

we tried clear pppoe all ( session disconnected and reconnected) but still issue is there

Video send for your reference, please check

debug pppoe packet

debug ppp negotiation

share both if you can 

in end do 

undebug all 

MHM

 

please find the details

ASR2#debug pppoe packets
PPPoE control packets debugging is on
ASR2#debug
ASR2#debug ppp negotiation
PPP protocol negotiation debugging is on
ASR2#undebug
ASR2#undebug all
All possible debugging has been turned off

can i share my screen ?

Review Cisco Networking products for a $25 gift card