AIM-ATM card install

[alison.hou]

   After installing the card, I configured :

controller T1 10/3/0

mode atm aim 1

framing esf

clock source internal

linecode b8z

But show controllers indicated it was down as follow.  did that mean the card is faulty? or maybe a circuit problem? Anything I was missing?

CAHSIBCDE#show controllers t1

T1 0/3/0 is down.

  Applique type is Channelized T1

  Cablelength is long gain36 0db

  Receiver has remote alarm.

  alarm-trigger is not set

  Soaking time: 3, Clearance time: 10

  AIS State:Clear  LOS State:Clear  LOF State:Clear

  Version info Firmware: 20050620, FPGA: 16, spm_count = 0

  Framing is ESF, Line Code is B8ZS, Clock Source is Internal.

  CRC Threshold is 320. Reported from firmware  is 320.

  Data in current interval (850 seconds elapsed):

     0 Line Code Violations, 0 Path Code Violations

     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 850 Unavail Secs

  Total Data (last 24 hours)

     481 Line Code Violations, 1555 Path Code Violations,

     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,

     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 86400 Unavail Secs CAHSIBCDE#show controllers t1

thanks,

alison

[vmiller]

first thing, why is clock source internal? change it to line.

[alison.hou]

thank you. I changed it line. The controllers are still down.

[paolo bevilacqua]

CAHSIBCDE#show controllers t1

T1 0/3/0 is down.

  Applique type is Channelized T1

  Cablelength is long gain36 0db

  Receiver has remote alarm.

Possible faulty circuit, or remote down.

[nspasov]

Also, can you post your config that includes the "clocking" commands. More specifically, I am looking to see if your aim module is set to participate in the clocking process. The command would be like this:

network-clock-participate aim 1