06-27-2012 12:36 AM - edited 03-04-2019 04:48 PM
Hello,
we have over 100 AP1242 with c1240-k9w8-mx.124-23c.JA2 image, tow 5508 controller and WCS running. After the ap reboots, the duplex settings of the fa0 interface change to half duplex. I have to set it manually to full duplex. In my WCS or with the 5508 controller I have no chance to set the duplex settings for my ap's.
Best regards,
Hubert
Solved! Go to Solution.
06-27-2012 04:39 AM
if your problem solved with these helps, then please mark this question as answered, may be it helps for others.
Regards
Please rate if it helps.
06-27-2012 12:40 AM
Hi Hubert,
Try followings:
AP interface configuration:
1) WLC GUI -> Wireless -> Click on the AP -> Advanced -> Select "Telnet"
2) WLC GUI > Wireless -> Global Configuraion -> Configure Username and Password under "Login Credentials".
3) Telnet to the AP. then use following commands:
config t
interface g0 or f0)
duplex full
Regards
please rate if it help.
06-27-2012 12:55 AM
Hi,
I always use a ssh session to the AP to set the "duplex full" command to the fa0 interface. What is the differece to telnet over the WCS?
Best regards,
Hubert
06-27-2012 01:11 AM
Frankly speaking there is no need to set the setting of an AP.
usually ..just plug the AP to switch with default seetting and run away but if you are changing then ...you can do by telnet or ssh....its same.
Regards
please rate if it help.
06-27-2012 02:47 AM
Sorry, I always plug the AP to the switch but an reboot from the switch or AP set the AP in half duplex mode. Then I have to set full duplex manually for the time to next reboot.
Regards
Hubert
06-27-2012 03:46 AM
HI ,
I am also using the same 1242AP.....so i can say that...it is not a bug.
Cisco Wireless products work best when both speed and duplex are autonegotiated, but you do have the option to set the duplex settings on the WLC and LAPs. In order to set the AP speed/duplex settings, you can configure the duplex settings for the LAPs on the controller and then, in turn, push them to the LAPs. configure ap ethernet duplex
Regards
please rate if it helps.
06-27-2012 04:00 AM
Ok. My APs were in auto mode for duplex and speed originally. Speed works fine but duplex not. So I will try the
configure ap ethernet duplex
Many thanks and best regards,
Hubert
06-27-2012 04:39 AM
if your problem solved with these helps, then please mark this question as answered, may be it helps for others.
Regards
Please rate if it helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide