Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,we have over 100 AP1242 with c1240-k9w8-mx.124-23c.JA2 image, tow 5508 controller and WCS running. After the ap reboots, the duplex settings of the fa0 interface change to half duplex. I have to set it manually to full duplex. In my WCS or with...
Hi,LMS 4.0 shows "could not detect SSH protocols running on the device. Failed to fetch config using SCP.Connection timed out: connect Verify SCP is enabled or not."SSH and SCP are enabled on all of our switches. On some switches it works on other no...
Hi,on my c2960s-24-TS-L switch I have configured aaa, ssh and a user with privilege 15. When I open a ssh connection to the switch and login as the privileged user, I am not in the enable mode. On my 2960G switches it still functioning.Best regards,H...
Hi all,I have setup an oeap 600 and it joins the primary controller 5508. The corporate SSIDs are showed in the wlan client but the client cannot connect to the SSID.The event_log from the oeap shows:*Dec 15 16:14:30.807: ADD_MOBILE from WLC,wmeEnabl...
Ok. My APs were in auto mode for duplex and speed originally. Speed works fine but duplex not. So I will try the configure ap ethernet duplex speed for my APs and I hope this will help.Many thanks and best regards,Hubert
Sorry, I always plug the AP to the switch but an reboot from the switch or AP set the AP in half duplex mode. Then I have to set full duplex manually for the time to next reboot.RegardsHubert
Hi,I always use a ssh session to the AP to set the "duplex full" command to the fa0 interface. What is the differece to telnet over the WCS?Best regards,Hubert
