ASA 5510 9.4 routes

[mazbiletn55]

Hi i just started my ASA and uploaded IOS from TFTP succesfully but after booting while im trying to:
copy tftp flash i canot connect to my server because of no routes, and here is the issue.
Im issuing command:
route Manag 0.0.0.0 0.0.0.0 192.168.0.1 1

and it looks like its succesfully aded, it is when i type show run, but in show route there is nothing:
ciscoasa# sh route

Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP

D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP

i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area

* - candidate default, U - per-user static route, o - ODR

P - periodic downloaded static route

Gateway of last resort is not set

I had already done it succesfully this way but on 8.3,
What is the problem here?

[MHM Cisco World]

Show route management-only <<- here will defualt route to mgmt interface appear 

MHM

[Richard Burts]

In addition to the suggestion from @MHM Cisco World I would ask these questions:

- have you configured the management interface.

- have you configured an IP address on it in the subnet of 192.168.0.0.

- if so, is the management interface up?

[paul driver]

Hello
fyi - the mgt interface has is own separate route table - as it used for OOB mgt as such it acts just like its own vrf  so any all routes applied to the mgt will NOT be seen by checking the global route table (GRT)
as already suggested 
Sh route management-only will show the route table of the OOB management