ASR 9010 Heat Dissipation

[acharyr123]

Hi,

Can someone share the Heat Dissipation for ASR 9010??

Rgds,

Partha

[Robert W. Rogier]

Hi,

     I believe this is what you were looking for.  I found them in the hardware specification guide on the CCO site:

Table A-5     ASR 9006 AC Electrical Specifications

Description	Value
Total AC input power	3400 VA (volt-amps) per AC power supply (up to three AC power supply modules per system)
Rated input voltage1	200-240 VAC nominal (range: 180 to 264 VAC) 220-240 VAC (UK)
Rated input line frequency1	50/60 Hz nominal (range: 47 to 63 Hz) 50/60 Hz (UK)
Input current rating1	15 A maximum at 200 VAC 13 A maximum at 220 to 240 VRMS (UK)
Source AC service requirement1	20 A North America; 16 A international; 13 A United Kingdom
Redundancy	At least three AC power supply modules are required for N+1 redundancy for a fully configured system.

¹ For each AC power supply module.

Table A-6 lists the DC electrical specifications for the Cisco ASR 9010 Router.

Table A-6     ASR 9010 DC Electrical Specifications

Description	Value
Total DC Input Power	2300 W per DC power supply module (2100 W output module) (up to six DC power supply modules per system) 1700 W per DC power supply module (1500 W output module) (up to six DC power supply modules per system)
Rated input voltage1	-48 VDC nominal in North America -60 VDC nominal in the European Community (range: -40.5 to -72 VDC [-75 VDC for 5 ms])
Input current rating2	49 A maximum at -48 VDC nominal 39 A maximum at -60 VDC nominal
Source DC service requirement1	Sufficient to supply the rated input current. Local codes apply.
Redundancy	At least three DC power supply modules (in either power shelf) are required for N+1 redundancy for a fully configured system.

¹ For each DC power supply module.

² For  each DC power supply module. Some power/chassis configurations may  operate at lower current ratings than those specified in this table.  Contact your Cisco technical representative for more information.

[Lie Suherman]

Hi Robert,

I want to ask about the power requirements above. I used to install the asr with the DC power. from your requirements above, the input current rating is 49A maximum at -48Vdc.

So, if we want to install 6 power supply modules on asr9010, it means that we need about 300A for 6 power modules. Am i correct ?