ASR1006 ASR1000-RP2 Unknown state after CPLD upgrade

[ez9]

Hello,

I tried to upgrade the CPLD version on one ASR1000-RP2 card. The upgrade is finished ok and the cli prompts for a power cycle. I check with the command (show upgrade hw-programmable progress) and I proceeded to a power cycle but the RP is not powering anymore. All leds are switched off (including power led). I tried to boot the chassis using another RP and execute some commands:

#show diag slot R1 eeprom detail
Slot R1 EEPROM data is not initialized

#show inventory

 NAME: "module R1", DESCR: "Cisco ASR1000 Unknown Route Processor"
PID: ASR1000-RP-UNKNOWN, VID: , SN:

#show platform

Slot Type State Insert time (ago)
--------- ------------------- --------------------- -----------------

R1             unknown      00:07:26

Do you have any suggestions for this issue?

[Leo Laohoo]

---

@ez9 wrote:

Is there anything else that I can try?

---

Check the used market for any available router or parts.  

[ez9]

Thanks for the support. Is there any way (like debug mode) to detect the issue? eg damaged RAM module etc? 

[Leo Laohoo]

---

@ez9 wrote:

Thanks for the support. Is there any way (like debug mode) to detect the issue? eg damaged RAM module etc? 

---

Only TAC will know how to.

[marce1000]

 -     You may scrutinize output from show tech-support , but I am not optimistic.

 M.