07-03-2021 09:53 AM
Hello,
I tried to upgrade the CPLD version on one ASR1000-RP2 card. The upgrade is finished ok and the cli prompts for a power cycle. I check with the command (show upgrade hw-programmable progress) and I proceeded to a power cycle but the RP is not powering anymore. All leds are switched off (including power led). I tried to boot the chassis using another RP and execute some commands:
#show diag slot R1 eeprom detail
Slot R1 EEPROM data is not initialized
#show inventory
NAME: "module R1", DESCR: "Cisco ASR1000 Unknown Route Processor"
PID: ASR1000-RP-UNKNOWN, VID: , SN:
#show platform
Slot Type State Insert time (ago)
--------- ------------------- --------------------- -----------------
R1 unknown 00:07:26
Do you have any suggestions for this issue?
07-07-2021 01:19 AM
@ez9 wrote:
Is there anything else that I can try?
Check the used market for any available router or parts.
07-07-2021 04:13 AM
Thanks for the support. Is there any way (like debug mode) to detect the issue? eg damaged RAM module etc?
07-07-2021 04:15 AM
@ez9 wrote:
Thanks for the support. Is there any way (like debug mode) to detect the issue? eg damaged RAM module etc?
Only TAC will know how to.
07-07-2021 07:42 AM
- You may scrutinize output from show tech-support , but I am not optimistic.
M.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide