05-09-2016 03:17 PM - edited 03-05-2019 03:58 AM
Hi I tried "show route x.x.x.x/x detail" command but the output didn't include the community value. Is there a different command to verify that information?
05-10-2016 12:55 PM
anyone?
05-10-2016 01:01 PM
nvermind found it-- we can do sh bgp x.x.x.x/x and that will show the community associated with it
05-10-2016 06:29 PM
You can also remember the format of the commands as below:
show bgp <afi> <safi> <prefix>, where AFI can ipv4, ipv6, vpnv4, vpnv6 or any other address-family and the SAFi value can be either unicast or multicast based on what you have configured.
Hope this helps.
Regards
Vinit
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: