02-22-2006 02:29 PM - edited 03-03-2019 11:50 AM
Im helping a friend out with an ATM issue. User are complaining of slow speeds across the WAN Heres the setup Adtran Router -> Watch Guard Firewall -> Cisco 2900s. Im seeing a lot of CRC errors, tons of runts on the PVC but not seeing any errors on the eth interface of the router? Pings out fine, even with a 5000 buffer. Telnet no problem. The Telco came back with a clean circuit. Id like to think its a duplexing error? But I cant find a thing to support that theory. To make matters worst Ive never had to deal with ATM or Adtran Any Ideas
02-22-2006 02:33 PM
Hi,
I would check the ATM shaping rate on the router first and see that it matches the configured PCR/SCR on the ATM circuit.. CRC errors means that you are losing ATM cells somewhere in the middle. It is possible that your shaping parameters are incorrect resulting in drops in the ATM network.
Hope that helps - pls rate the post if it does.
Paresh
02-23-2006 12:47 AM
Dear Jhopper1313,
SPecifiy the duplex and speed under the sitch ports that connected to your router & firewall and specify the duplex under the router and firewall interfaces, because the different in speeds may result in packet loss and CRC's, for Ex if the router interface is Ethernet so under the switch port specify duplex full speed 10 etc...
Please rate helpful posts
Best Regards,
Mounir Mohamed
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide