Auxillary port diabled(urgent)

[Dinesh Kumar Mariappan]

                   How to check whather auxilary port is disabled or enabled in Router,switches, Cisco ACE and firewall.

is there any command is there is check the logging status( at what level it was configured ), not sure about this..

[mvsheik123]

Hi,

I guess the Aux port considered as tty line 1. I don't think you can 'shut' the port, but you can configure 'transport input none' to block any incoming connections. (conf t/ line tty 1).

Some commands to check:

Show line

show line tty 1

show run | include line tty 1

hth

MS