12-04-2010 06:34 PM - edited 03-04-2019 10:41 AM
I'm troubleshooting my advertise-map and I see it showing up twice in the running config. When I type the "no" form it removes both instances and when I readd it, it appears twice again.
router bgp 1000
neighbor 10.10.10.2 remote-as 1001
neighbor 10.10.10.2 password 7 XXXXXXXXXXXXXXX
neighbor 10.10.10.2 update-source Loopback0
address-family ipv4
neighbor 10.10.10.2 activate
neighbor 10.10.10.2 send-community
neighbor 10.10.10.2 advertise-map COND_XXXXXX-XX-XXXX_XXX exist-map UP
neighbor 10.10.10.2 route-map IN in
neighbor 10.10.10.2 route-map OUT out
neighbor 10.10.10.2 advertise-map COND_XXXXXX-XX-XXXX_XXX exist-map UP
Version 12.2(33)SRB2
12-04-2010 07:40 PM
Hello machael,
It seems like it is kind of bug because it seems illogical. Do you face any problem in advt. due to this?
you can post problem if you have faced any. But I did not find any supporting bug
This is kind of issue with me where i can see fake eigrp config under address-family with 7600/SRB2 but i do not face
any routing issue due to this
Regards
Mahesh
12-04-2010 08:01 PM
The Status never changes to "Withdrawn" when the condintion stops showing up in the BGP table.
12-04-2010 08:28 PM
Hello Michael,
If you are confident about the config i advise you to log a case with cisco.
Regards
Mahesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide