Showing results for 
Search instead for 
Did you mean: 

BGP multihoming with 2 different ISP, without own public ip address/ASN


Currently we are using ISP A given /26 public ip address, and we couldn't get /24 public from Internet Registry for some reason. Is it possible to setup BGP multihoming using ISP A /26 public ip address and then subscribe another link with ISP B (backup link)? In case ISP A link down, the /26 public ip address still can reach through ISP B link?

5 Replies 5

Giuseppe Larosa
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

Hello @TN28396,

if you haven't your own public IP address space you will need a second address block from ISP B.


>> In case ISP A link down, the /26 public ip address still can reach through ISP B link?

Generally this is not possible unless ISP A and ISP B are involved and agree on this.


More likely ISP B will give you a separate address block of its own,

You need to configure NAT in such a way that when ISP A is down you will use the address block provided by ISP B.


There was a nice design guide on the cisco site for this scenario.


Hope to help



may i have the link for your mentioned design guide?

Hello @TN28396,


the place to look is here


Unfortunately that specific whitepaper is not here.


Hope to help



paul driver
VIP Expert VIP Expert
VIP Expert

Are these provider independent allocations if so they are not tied to any local internet registry they follow you around to the ISP you want to peer with.

If I understand you correctly I think what you are asking you cannot done, the subnet you have been assigned cannot be split to peer with two independent ISP’s at the same time, but you can peer with your PI subnet and also obtain a PA subnet from ISP B and obtain resiliency that way.

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards

Currently our server is using ISP A public ip address without NATing, is there any way i can use ISP B public ip for the server when ISP A link down.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers