cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
220
Views
2
Helpful
4
Replies

BGP Question- Urgent

vinodbharwani
Beginner
Beginner

Hi Friend

I have One office & it is connected by two different ISP1 and ISP 2 ( Different AS number ), I have two 2 mb link between them. Now i want to configure traffic in such way one link use only 60 % with ISP1 and other link to IPS2 is using 40% traffic, How i can configure this ?

-V

4 Replies 4

sirdudesly
Explorer
Explorer

quality of service?

shivlu jain
Contributor
Contributor

or you can use the policy based routing. In PBR you can match the source and assign the next hop addresses.

regards

shivlu

bvsnarayana03
Contributor
Contributor

You may be having definite reasons for doin this, otherwise make full use of the pipe you are paying for. There are some QoS techniques for doing this. Rate-limiting, shaping & policing are some features.

Refer this link for understanding:

http://www.cisco.com/en/US/docs/ios/12_0/qos/configuration/guide/qcpolts.html

Joseph W. Doherty
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

For outbound, but not practical for inbound, if your routers support OER/PfR, you can configure load ratios.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers