Routing

I wonder if anyone has created his or her own applet that combines using a custom application logon with the VPN SSL client (like SSO)that provides a single interface for the user. I realize that creating custom web portal is the easiest thing to do...

I need to provide a router which will be able to:a) Allow VPN connectivity/tunnel via ther Internet b) In the future, connect to MPLS network (10Mbps circuit)Is the 1841 sufficient for this, or should I look into the 2851?

Hi, Customer wants to use 2 independent networks termiated on one common switch and wants to use the networks based on time. We can have time based ACL but customer wants to have time based port shutdown and no shutdown to get more security.Please, l...

Just been going through QoS and labbing a few things and have come up with a problem.When QoS is configured on a service provider ethernet link for instance a 4Mbps symmetric, queuing doesn't seem to work correctly in that most of the congestion cont...

Hello,We currently have a multihomed Cisco 1811 running IOS 12.4.FastEthernet0 (FE0) is assigned 1.1.1.1 from ISP-A. FastEthernet1 (FE1) is assigned 2.2.2.2 from ISP-B.OER is configured and working well.The problem I have is sometimes (randomly) vari...

I have version 7.2(1) on asa 5510. Due to reverse route putting a static route on my routing table. When the tunnel goes away shouldn't the static route go away also?

Has anyone tried configuring 2 RR's of same cluster as clients to each other.Logically it should work as reflected routes from 1 RR to other RR will have cluster Id attached hence the peer RR will not accept the route.Any suggestion???

HiIs it possible to use a ip prefix-list on a sub-interface? Alan

Hi all,We have links to two differnt ISPs. We recieve partial routing entries and default from both, however only one default route appears in the routing table. This is a problem for us as large amounts of traffic are still using the default route, ...

I get an error %USB_HOST_STACK-3-USB_FLASH_READY_TEST_FAILED : USB flash failed to pass 'Ready' test when I connect a 2gig usb drive to a router with version 12.4(11)T4.Can anyone suggest any remedy?

Hi all I have cisco 1841 router with hwic-2shdsl card. IOS c1841-advipservicesk9-mz.124-15.T3.binI need to connect Zyxel IES-1000+SAM1008 in mode 4wired.Config on Cisco:controller SHDSL 0/0/0 dsl-group 0 pairs 0, 1 shdsl annex B shdsl rate autoCon...