cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
326
Views
0
Helpful
1
Replies

bgp route question

Amafsha1
Level 2
Level 2

Hello,

 

When executing the command "show bgp all" on our WAN router I get the following entries for example:

 

WAN#sh bgp all
For address family: IPv4 Unicast

BGP table version is 400201, local router ID is 10.0.0.32
Status codes: s suppressed, d damped, h history, * valid, > best, i - internal,
r RIB-failure, S Stale, m multipath, b backup-path, f RT-Filter,
x best-external, a additional-path, c RIB-compressed,
Origin codes: i - IGP, e - EGP, ? - incomplete
RPKI validation codes: V valid, I invalid, N Not found

Network Next Hop Metric LocPrf Weight Path
*> 10.30.202.0/24 63.1.1.153 0 108 ?
*> 10.60.208.0/24 63.1.1.153 0 108 108?

Why does it show AS 108 twice on the 2nd route for going to the 10.60.208.0 network?

1 Reply 1

Alan Ng'ethe
Level 3
Level 3

The ISP may be using the AS PATH PREPEND feature to alter the metrics. 

Remember to rate helpful posts and/or mark as a solution if your issue is resolved.
Review Cisco Networking for a $25 gift card