brom> boot on 2960XR switch

[ewood2624]

We received a new 2960XR switch and on initial boot it goes into brom> mode.

CPU rev: B
Image passed digital signature verification
Board rev: 6
Testing DataBus...
***ERR -- Data bit 3: Expected = 0xfffffff7, Actual = 0xfffffff3, at addr 0x00000000.
Going to MayDay...
Xmodem file system is available.
flash probe successful
create ifs brom
create ifs bs

brom>

Is this the same as ROMMON mode?  I can't find too much out there on brom> mode.

[Leo Laohoo · Accepted solution]

Nope.  This process happens before ROMmon.  

This means your appliance is dead.  You may need to contact Cisco TAC and arrange for a replacement.

[Arnoldo]

Hi 

I have the same problem, as I've fixed?

this is what it shows:

reset

Are you sure you want to reset the system (y/n)?y

System resetting...

CPU rev: B
Image passed digital signature verification

Board rev: 5
Testing DataBus...
***ERR -- Data bit 0: Expected = 0xfffffffe, Actual = 0xfffe, at addr 0x00000000.
Going to MayDay...

Xmodem file system is available.

flash probe successful

create ifs brom

create ifs bs

brom>

[pranab.picku@gmail.com]

CPU rev: B
Image passed digital signature verification
Board rev: 5
Testing DataBus...
Testing AddressBus...
Testing Memory from 0x00000000 to 0x1fffffff...-
***ERR -- Memory test failed
Expected = 0x44454647, Actual = 0xc4c5c6c7 at address 0x00001100
Going to MayDay...
Xmodem file system is available.
flash probe successful
create ifs brom
create ifs bs

brom>

Kindly  help me?

sonjubaba56@gmail.com

[SaubhagyaMishra7219]

Hi All,

One of my customer is facing the same issue.

Any one having a solution to boot into rommon mode or normal mode from brom mode?

[snkshabeer]

Hi,

Disconnect power cable from ur switch then remove power module from the switch for 2-3 minutes. Reconnect then see.

Good day

[fabivian]

Hi, Community,

I have the same problem but the equipment doesn't have support, what do you recommend?