c891F Memory Upgrade

[curtis.rutter]

I recently installed a memory license upgrade (FL-8XX-512U1GB) on a c891F ISR. The license install <filename> command reported successful installation. However, a show version command still reports 512MB of memory and the license information doesn't include anything about the memory upgrade license (post reload). Is there any command that shows that the router is, in fact, using the 1GB allowed by the license?

This link contains a table, memory options, that shows the 891F memory upgrade feature option: http://www.cisco.com/c/en/us/products/collateral/routers/800-series-routers/data_sheet_c78-519930.html

[Jaromir Holy · Accepted solution]

Hi Curtis,

Have you tried "license feature MEM-8XX-512U1GB" command in configuration mode and then wr and reload?

BR,

Jaromir

[curtis.rutter]

We've sent this router to the customer site, so I'll have to see if we can remote in and run the command. Thanks for the suggestion.

Update: The tech on site issued the "license feature MEM-8XX-512U1GB" and rebooted the router. That resolved the issue.

Thanks for the help!