Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
Labels

Forum Posts

Start a conversation

MPLS performance over IP network

Hi ALL, We know that MPLS forwards packet faster compared to traditional IP network, But how can I prove that by practically (by using some stimulations). Can anyone please suggest or provide proof. Thank You,

Neelesh M by • Level 1
  • 1666 Views
  • 4 replies
  • 0 Helpful votes

Resolved! eBGP Mesh - Redundancy failing

Hi all, I've the following problem which I hope people can help me with. I've built a lab as proof of concept. The topology is attached.   > There are 4 sites,  each site is connected via two separate VPLS networks. The aim is that as long as there i...

Resolved! No Telnet after NAT outside

I used to be able to Telnet through my WAN interface during the configuration of my 871 router before I set up nat outside. I can still Telnet and SSH from an internal address. Now I am getting failed connections for both Telnet and SSH through the W...

Resolved! Routable IPs behind Cisco 887VA

Hello,I have a block of eight routable IP addresses from my ISP.  I have a Cisco 887VA that I want to use as my router.  I know the router will take one of my IP addresses, but I'm having a problem getting the other IP addresses to route through the ...

gordon855 by • Level 1
  • 3340 Views
  • 9 replies
  • 0 Helpful votes

4G-LTE-G ehwic on 1921

I'm trying to get a 1921 router with the "EHWIC-4G-LTE-G" connection to work and I can't seem to get it right, here's some info.!controller Cellular 0/1 lte sim authenticate 7 xxxxxxxx!interface GigabitEthernet0/1 description *** inside ip address 19...

BGP and QOS

Hi all, I need to apply QoS to control the traffic, I have a group of routers that are using BGP as routing protocol.Is it possible to apply QoS LLQ if I'm using BGP?It would be great if you can share an example.Thanks a lotDavid.

Cisco 871 Router VLAN

Hi, I am trying to configure 2 VLANS on my Cisco 871 router. VLAN 10 & VLAN 20.VLAN 10 is for my VoIP.VLAN 20 is for my Data. My physical connection is this: ISP > Cisco 871 > Unmanaged Switch > All DevicesSo I have My ISP connected to FastEthernet 4...

odannycx by • Level 1
  • 620 Views
  • 2 replies
  • 0 Helpful votes

Resolved! subnet advertisement with different BGP peer

Hi expert, This might be a stupid a question. But just bear with me. Am actually a noob in BGP, so your help is greatly appreciated.I have the below scenario: Three providers P1 subnets: 1.1.1.0/24, 2.2.2.0/24P2 subnets:  3.3.3.0/24 4.4.4.0/24P3 subn...

Resolved! Cisco 871 Routers

Hi Guys,This series of routers has a built in switch. I understand that to enable routing the switch ports must become part of a configured vlan on fe0,fe1,fe2 and fe3. Fe4 does not have a layer 2 port and is layer 3 only. On the device fe4 is clearl...

Load more