cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
548
Views
0
Helpful
2
Replies

Cellular 0 in router 881G isn't up

Hi all:

I'm trying to have internet access in a 881G router through sim I introduced. The operator is Vodafone and I know 3G is working fine cause HSPA works out well if you introduce sim in a mobile, activate 3G and try surf.

I just called Vodafone and they confirmed the APN, user, pass and authentication are correct so I understand there is a configuration issue in the router. The config I've got nowadays is very simple:

 

Router#sh run
[output supressed]
multilink bundle-name authenticated
chat-script gsm "" "AT!CALL1" TIMEOUT 20 "OK"
license udi pid C881G+7-K9 sn FCZ184190MC
!
controller Cellular 0
!
interface FastEthernet0
 no ip address
!
interface FastEthernet1
 no ip address
!
interface FastEthernet2
 no ip address
!
interface FastEthernet3
 no ip address
!
interface FastEthernet4
 no ip address
 shutdown
 duplex auto
 speed auto
!
interface Cellular0
 ip address negotiated
 ip nat outside
 ip virtual-reassembly in
 encapsulation slip
 load-interval 30
 dialer in-band
 dialer idle-timeout 0
 dialer string gsm
 dialer-group 1
 no peer default ip address
 async mode interactive
!
interface Vlan1
 ip address 192.168.1.1 255.255.255.0
 ip nat inside
 ip virtual-reassembly in
!
ip forward-protocol nd
no ip http server
no ip http secure-server
!
!
ip nat inside source list 1 interface Cellular0 overload
ip route 0.0.0.0 0.0.0.0 Cellular0
!
access-list 1 permit any
dialer-list 1 protocol ip permit
!
!
control-plane
!
!
!
line con 0
 no modem enable
line aux 0
line 3
 script dialer gsm
 modem InOut
 no exec
 transport input all
 transport output all
line vty 0 4
 login
 transport input all
!
!
end

Router#

 

I realized if I launch show interface cellular 0 commando I can see the next:

 

Router#sh int cell 0
Cellular0 is up (spoofing), line protocol is up (spoofing)
  Hardware is 3G Modem-QuadBand HSPA+R7/HSPA/UMTS QuadBand EDGE/GPRS Global and GPS
  Internet address will be assigned dynamically by the network
  MTU 1500 bytes, BW 9 Kbit/sec, DLY 100000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation SLIP, loopback not set

 

Thanks and regards

Francisco

2 Replies 2

martino-cisco
Level 1
Level 1

Hi,

Were you able to resolve this? I've having the same issue

Hi martino

Yes, I managed to fix it. The problem is I no longer work in the company where I configured the routers so I couldn't see the configuration.

As far as I remember, the problem was in the chat-script used. Sorry for not being more helpful.

Regards

Review Cisco Networking for a $25 gift card