Hi All,
I have cisco 1801 router with 8 ports.
I am trying to setup two different vlans on this equipment. fa 1 is connected to my LAN and Fa 2 is connected to my WAN.
I want to have a vlan 1 used by Fa 0 and vlan 2 used by fa 2. Can you please check my config and let me know of any configuration problem?
interface FastEthernet1
!
interface FastEthernet2
!
interface FastEthernet3
!
interface FastEthernet4
!
interface FastEthernet5
!
interface FastEthernet6
!
interface FastEthernet7
!
interface FastEthernet8
!
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
!
interface Vlan1
description $LAN$
no ip address
ip tcp adjust-mss 1452
bridge-group 1
!
interface Vlan2
description $WAN$
no ip address
ip tcp adjust-mss 1452
bridge-group 2
!
interface BVI1
description $LAN$
ip address 10.16.1.0 255.255.255.0
!
interface BVI2
description $WAN$
ip address 10.16.2.0 255.255.255.0
!
bridge 1 protocol ieee
bridge 1 route ip
bridge 2 protocol ieee
bridge 2 route ip
