The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
BTW, Cisco rates the 1921 for WAN circuits up to 15 Mbps, and that recommendation is for about every possible concurrent service. So, as Edison says too, 10 Mbps should be fine.
Oh, do be cautious with FE or gigE interfaces. The 1921 could have an issue with a transient large burst at high speed even if it easily can sustain 10 Mbps.
Hi, I have installed a DNAC on 10.10.8.10 and and have installed Fabrics and LAN Automation and so on.But now I am trying to PnP a 2960-C switch and cannot get it to registrer on the DNAC. I have configured the DHCP Scope as follows: ...
To provide a solution to quickly setup a router at a remote location that supports WiFi and provides instant internet access using LTE as a transport while deploying with Cisco SD-WAN.
Plug the router to a power sou...
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment. This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ...
Hi all,I have a couple of Nexus9k switches. I need to get tcpdump from the physical interface which connected to the server. I'm looking for a specific protocol on tcpdump so that which feature should I use? I asked that because I couldn't full...
We are building out our first few AAR polices and are running into an error message.Built Global Policy with SLA class and traffic rules for voice traffic, attached to to the sites and VPN we needed, no issue. Building a second policy for management ...