Cisco 2960 setup no access to internet

[jk865]

Hi

I have bought a 2960 switch to work on as I am studying for my CCNA , Im trying to incoperate it into my home network the diagram goes like this

BT Router > Netgear switch (unmanaged) > Patch pannel > 2960 switch

I have set the default gateway and my pc gets an IP address but no access to the internet, I have also added all ports to VLAN 1

Can anyone help please and thanks

[M02@rt37]

Hello @jk865,

Does the PC ping its Gateway ?

[jk865]

Yes

[M02@rt37]

OK @jk865 

Does the PC ping 8.8.8.8 ?

If yes, do you have DNS configon PC's IP configuration ?

[jk865]

Yes I can ping 8.8.8.8 sucsesfully , no DNS configon set to obtain automatically

[M02@rt37]

You need DNS IP config on your PC @jk865 

[jk865]

What should it be set to? Thanks

[M02@rt37]

@jk865 

Which equipement give the DHCP configuration ? It is this equipement that send also the option DHCP concerning IP of DNS server. It is the BT Router ? 

[jk865]

The BT Router at the moment is the DHCP provider

[jk865]

Still the same with this config

[M02@rt37]

Try 8.8.8.8 @jk865 

[jk865]

Same issue

[M02@rt37]

@jk865 

Also, your PC is plug on Fa 0/3?

If yes delete the command line "dhcp ..." under that Fa 0/3, do on your PC an ipconfig /renew and see if you receive the DNS IP with from DHCP provider.

[M02@rt37]

@jk865 

On your screenshot you are not in DHCP mode. Please select "obtain an IP dynamically" and see what the PC receive.

[jk865]

Ive tried both,

I just reset everything to try again but same issue, I think the hub is giving out IPv6 addresses and this could be an issue? Fa01 is hub , Fa02 is PC