09-29-2009 01:47 AM - edited 03-04-2019 06:12 AM
Hello,
I want to my use Cisco 878 Router as a Bridge and want to make the PPPoE authentication at my different brand firewall. is that possible ?
thanks for your all comments.
09-29-2009 01:48 AM
Yes, just put atm and ethernet inteface in a bridge group.
09-29-2009 02:00 AM
Hi,
please forgive my stupidity,
could you please give me a configuration example about it ?
09-29-2009 02:11 AM
Use the search box top right corner, for that and more.
09-29-2009 03:07 AM
thanks for your fast reply,
when I try to do put fastethernet to bridge-group it says the following message:
HSM(config-if)#bridge-group 1
FastEthernet0 does not support bridging
is it a fixible issue ?
thank you so much.
09-29-2009 03:15 AM
Bridge-group to VLAN1.
09-29-2009 04:02 AM
hi again,
sorry being headacke to you.
now my vlan1 is up bu I couldn't up my atm interface. it says down all the time.
do you have any idea why is that for ?
thanks a lot
09-29-2009 07:00 AM
Check with ISP which service you have contracted and that they have activated it.
09-29-2009 07:27 AM
hi,
thank you for all your advices. it has been very helpful to me. I solved my problem. thank you again.
09-29-2009 07:29 AM
You are welcome, please remember to rate useful posts with the scrollbox below.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide