CIsco 9300L switch autoinstall feature

[kdsingh007]

how to stop this autoinstall ? it doesn't let me enter anything on the console. Below is the output off cisco Model Number : C9300L-24UXG-4X

"No startup-config, starting autoinstall/pnp/ztp...

Autoinstall will terminate if any input is detected on console

--- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]: Jul 9 21:46:15.451: %IOX-3-IOX_RESTARTABITLITY: R0/0: run_ioxn_caf: Stack is in N+1 mode, disabling sync for IOx restartability

Autoinstall trying DHCPv6 on Vlan1

Autoinstall trying DHCPv4 on Vlan1

Autoinstall trying DHCPv6 on Vlan1

Autoinstall trying DHCPv6 on Vlan1.

[Leo Laohoo]

conf t
 no service config
end

[kdsingh007]

it doesn't let me enter anything on CLI as I cannot terminate this autoinstall feature

[Torbjørn]

You should be able to send characters to the switch over serial, and auto-install should stop once you start configuring the switch.

Are you sure that your console cable/settings are correct? Could you verify by attempting to connect to another switch?

[kdsingh007]

console settings are ok and working on other cisco routers and switches