ANNOUNCEMENT - The community will be down for maintenace this Thursday August 13 from 12:00 AM PT to 02:00 AM PT. As a precaution save your work.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
172
Views
0
Helpful
4
Replies
Highlighted
Beginner

Cisco ASA Static Routing 2020

I've been searching around the community and found several older articles that match what I'm talking about but the answers don't seem to work with the newer ASA code.  Forgive my ignorance on this please as this is the first time I've ever done static routing with an ASA.

 

We have our inside network at 10.23.101.0/24

I have an inside static route for 10.1.10.0/24 pointing to 10.23.101.254.  I can ping 10.23.101.254 and if I put a static route on my workstation I can ping 10.1.10.6.

I've run the commands:

same-security-traffic permit inter-interface
same-security-traffic permit intra-interface

on the ASA but this isn't helping.  I've also re-created several NAT examples that I have found but it's not working.

 

The ASA is on version 9.8(2).

 

The ASA can successfully ping 10.1.10.6 but workstations pointing to the ASA as their default gateway can not.

 

Any help is greatly appreciated!  Thank you in advance!

 

4 REPLIES 4
Highlighted
VIP Mentor

Re: Cisco ASA Static Routing 2020

Hello


@WillieH81398 wrote:

The ASA can successfully ping 10.1.10.6 but workstations pointing to the ASA as their default gateway can not

So users on 10.23.101.0/24 cannot reach users on 10.1.10.0/24 correct?  What interfaces on the ASA do these two subnets reside?
Be good if you could post the ASA configuration in a file and attach it to the post?



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future
Highlighted
Beginner

Re: Cisco ASA Static Routing 2020

All of the internal interfaces are in a bridge -- do the physical still make a difference?

Highlighted
VIP Mentor

Re: Cisco ASA Static Routing 2020

Hello

Bridged interface inter-communication should still work, Do they have the same security level?

Can you post your configuration in a file and attach please



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future
Highlighted
Hall of Fame Guru

Re: Cisco ASA Static Routing 2020

I am not clear how ASA interfaces in a bridge work with multiple subnets and would like to see the config. But perhaps that is not the most important part of the questions here. The original post tells us that "I have an inside static route for 10.1.10.0/24 pointing to 10.23.101.254" So I would like to know more about the device at 10.23.101.254. 

 

 

HTH

Rick