cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
838
Views
0
Helpful
1
Replies

Cisco ASR1002 - no "monitor capture" command

Lee Kendrick
Level 1
Level 1

Hi,

I am trying to run a capture on one of my ASR 1002 routers, however the EPC monitor capture command is not available.

Please can someone provide some insight on how i can either resolve this or an alternative method.

I am not on site to make any physical changes:

RTWAN2#monitor ?                    

  call         Monitor call

  elog         Event-logging control commands

  event-trace  Control event tracing

  platform     Monitor platform information

  processes    Monitor processes

RTWAN2#

Many thanks

Lee

1 Reply 1

Vignesh Rajendran Praveen
Cisco Employee
Cisco Employee

Hi Lee,

The EPC feature is only available from 15.3(1)S IOS-XE version onwards.

http://www.cisco.com/en/US/partner/docs/ios-xml/ios/epc/configuration/xe-3s/asr1000/nm-packet-capture-xe.html

Kindly confirm the IOS-XE version that your using on the device. If possible share the show version output from the device.

****Plz do rate this post without fail if you found it to be helpful*********

Thanks & Regards,

Vignesh R P

Review Cisco Networking for a $25 gift card