Cisco C1111-8PLTEEA - Send AT commands to LTE modem module

[iaingray741]

Hi,

Can anyone tell me how/if I can issue AT commands to the LTE module in my C1111? (Sierra Wireless EM7455/EM7430).  I'm trying to get the output of the following - 

1. AT+CSQ              < Signal strength and BER-bit error rate>
2. AT+COPS?          <Serving network>
3. AT+COPS=?        <Available networks>
4. AT+COPS=0        <Network scan>

I'm doing some troubleshooting with my cellular provider and they're telling me they need this info to help me.

Thanks

[Georg Pauwen]

Hello,

the exec command 'start-chat' in combination with 'debug chat' used to be around, not sure if that is available on the C1111. The document linked below describes how this works for asynchronous lines, see if you can get this to work...

https://www.cisco.com/en/US/docs/ios/dial/configuration/guide/dia_modem_chat_scpts_external_docbase_0900e4b18060bbbb_4container_external_docbase_0900e4b18216dd1f.html#wp998412

[iaingray741]

Hi,

Thanks the start-chat & debug chat commands are there...but don't seem to do much on the C1111.  There's no line configuration required for the modem on their router, so nothing to address your chat to.