Cisco ISR4331/K9 Router with NIM-ES2-4

[Mohammad Al-Amin Sikder]

When i want to add NIM-ES2-4 Interface Card in the ISR4431/K9 Router in CCW, the Error is showing 'A selection of SSD is required when NIM-SSD is selected.'

is it necessary to add NIM-SSD when selecting NIM-ES2-4. ?

Can i just add NIM-ES2-4 as spare (ignoring the NIM-SSD Selection) ?

Urgent Suggestion Required.

[Philip D'Ath]

You don't need add NIM-SSD for a NIM-ES2-4.  You can just add NIM-ES2-4.

The error message in your screenshot shows you have selected a NIM-SSD - which obviously needs an SSD to make it a complete configuration.

[Mohammad Al-Amin Sikder]

Dear Philip

Thank you so much for your reply.

Please find the attachment showed in my previous post, i did not select NIM-SSD.  I just select the NIM-ES2-4, However it shows the error.

So that can i select NIM-ES2-4 as a spare ?

[Philip D'Ath · Accepted solution]

I would say this is a new bug in the Commerce Workplace tool, as I have not had that issue before.

So yes, I would select it as a spare.

[Mohammad Al-Amin Sikder]

Appreciate your Answer.

Thank you so much for your opinion.

[tesheth · Accepted solution]

was facing the same issue..

definitely an issue in CCW.

[william.a.bunyard]

Probably a CCW bug. I just experienced the same issue on a previously valid build. 

[Mohammad Al-Amin Sikder]

Finally Problem Solved...i'm so happy..now i can select NIM-ES2-4 Card without any error.

Thanks everyone.