Solved: Cisco Modeling Labs - CAT9300

Timothy Patrick · ‎04-27-2023

Hello, I have been playing around with both CAT9300V models in CML. I am trying to create a L3 port and setup eigrp neighbor between an IOSv device. when I create the L3 port I see the port in an UP UP state but I can not ping across to the other side

CAT9300V ---------- IOSv

10.252.247.6/30---------10.252.247.5/30

I am able to do a

show cdp

neighbor from the IOSv side

Device ID Local Intrfce Holdtme Capability Platform Port ID

Switch Gig 0/3 169 R S I C9KV-UADP Gig 1/0/1

but nothing from the 9300 side

Timothy Patrick · ‎04-27-2023

yes the port is up/up on both sides but I am unable to ping from 9300 to IOSv.

I switched it from 9300V Doppler to 9300V SiliconOne and it seems to work now. not sure what was going on

View solution in original post

M02@rt37 · ‎04-27-2023

Hello @Timothy Patrick,

When you say "but nothing from the 9300 side" you mean that you don't have cdp information on that equipement? 9300's port is UP/UP? The IP adress and mask configured are the good one?

Best regards
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.

Timothy Patrick · ‎04-27-2023

yes the port is up/up on both sides but I am unable to ping from 9300 to IOSv.

I switched it from 9300V Doppler to 9300V SiliconOne and it seems to work now. not sure what was going on

bashmyshell · ‎06-17-2023

Are the CAT9300V images supported by DNAC for services like SDAccess and PNP? I cannot find anything in the support matrix as of today, and haven't attempted it yet.