04-27-2023 04:53 PM - last edited on 04-27-2023 11:15 PM by Translator
Hello, I have been playing around with both CAT9300V models in CML. I am trying to create a L3 port and setup eigrp neighbor between an IOSv device. when I create the L3 port I see the port in an UP UP state but I can not ping across to the other side
CAT9300V ---------- IOSv
10.252.247.6/30---------10.252.247.5/30
I am able to do a
show cdp
neighbor from the IOSv side
Device ID Local Intrfce Holdtme Capability Platform Port ID
Switch Gig 0/3 169 R S I C9KV-UADP Gig 1/0/1
but nothing from the 9300 side
Solved! Go to Solution.
04-27-2023 10:26 PM
yes the port is up/up on both sides but I am unable to ping from 9300 to IOSv.
I switched it from 9300V Doppler to 9300V SiliconOne and it seems to work now. not sure what was going on
04-27-2023 09:56 PM - edited 04-27-2023 09:57 PM
Hello @Timothy Patrick,
When you say "but nothing from the 9300 side" you mean that you don't have cdp information on that equipement? 9300's port is UP/UP? The IP adress and mask configured are the good one?
04-27-2023 10:26 PM
yes the port is up/up on both sides but I am unable to ping from 9300 to IOSv.
I switched it from 9300V Doppler to 9300V SiliconOne and it seems to work now. not sure what was going on
06-17-2023 08:23 AM
Are the CAT9300V images supported by DNAC for services like SDAccess and PNP? I cannot find anything in the support matrix as of today, and haven't attempted it yet.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide